Differential scanning calorimetry (DSC) is a widely used tool to analyze thermal material properties. This study focuses on the advancement of a miniaturized DSC chip as an alternative to conventional devices. The first development steps for the integration of a weighing system are shown, starting with model considerations and simulation-based optimization to initial measurements. Three different measurement methods are investigated and show promising results.

The Physikalisch-Technische Bundesanstalt calibrated pyroelectric detectors at two independent primary radiometric standards regarding their spectral responsivity. The SI traceable measurements in the spectral range between 1.5 and 14 µm are consistent within the measurement uncertainty in the range of 1 % and 14 %. The importance of the correct read-out of lock-in amplifiers and the accurate consideration of the temporal shape of the chopped radiant flux behind the chopper wheel are shown.

A homemade experimental setup was developed using actuators and temperature sensors monitored by Arduino platforms to characterize thermal behaviors of composite panels containing phase-change materials (PCMs). The characterization is based on modeling steady-state thermal conduction and natural convection heat transfer. Temperature measurements allow for obtaining effective thermal conductivity, phase shift time, and energy storage capacity of composite panels incorporating PCMs.

Temperature measurement in engine and exhaust systems is necessary for thermal protection of parts and optimizing the combustion process. The basic idea of this novel sensor concept is to use thick-film technology on component surfaces. Different standardized and especially nonstandard material combinations have been produced for validation of this concept. Application-oriented measurements took place in the exhaust system of a test vehicle and were compared to standard laboratory conditions.

Hydrogen detection for purposes such as smart gas metering or fuel cell safety can be done by using a low-cost off-the-shelf thermopile IR radiation sensor and by driving it as a TCD (thermal conductivity detector). The MEMS thermopile sensor element is exposed to the measured gas environment. By applying an AC heating voltage to the thermopile structure and by measuring its DC output voltage, the hydrogen concentration of its gas environment can be measured with a resolution of up to 3.7ppm.